CLI Guide

Syntax omconfig storage controller action=enablealarm controller=id, where id is the
controller ID as reported by the omreport storage controller command.
Example to Disable the alarm on controller 1.
Example
omconfig storage controller action=disablealarm controller=1
Omconfig Quiet Controller Alarm
Table 155. omconfig Quiet Controller Alarm
Description Silences an activated controller alarm. For more information, see the Dell EMC OpenManage Online Help.
Syntax omconfig storage controller action=quietalarm controller=id, where id is the
controller ID as reported by the omreport storage controller command.
Example to Quiet the alarm on controller 1.
Example
omconfig storage controller action=quietalarm controller=1
omconfig Test Controller Alarm
Table 156. omconfig Test Controller Alarm
Description Tests the functionality of the controller alarm. The alarm sounds for about two seconds. For more
information, see Dell EMC OpenManage Online Help.
Syntax omconfig storage controller action=testalarm controller=id , where id is the
controller ID as reported by the omreport storage controller command.
Example to Test the alarm on controller 1.
Example
omconfig storage controller action=testalarm controller=1
Omconfig Reset Controller Configuration
Table 157. Omconfig Reset Controller Configuration
Description Resets the controller configuration.
CAUTION: Resetting a configuration permanently destroys all data on all virtual
disks attached to the controller. System or boot partition residing on these
virtual disks is destroyed. You may receive a warning message if this command
results in deleting the system or boot partition. However, this warning message
is not generated always. Ensure that you do not delete the system or boot
partition or other vital data when using this command.
Syntax omconfig storage controller action=resetconfig controller=id,
where id is the controller ID as reported by the omreport storage controller
command.
In some circumstances, you may receive a warning message if this command deletes the
system or boot partition. You can override this warning by using the force=yes parameter. In
this case, the syntax is as follows:
omconfig storage controller action=resetconfig
controller=id force=yes
Omconfig storage commands 153