CLI Guide

Required Command Levels (1,
2, 3)
Optional name=value pairs
action=cancelinitialize controller=id vdisk=id
action=cancelbginitialize controller=id vdisk=id
action=assigndedicatedhotspare controller=id vdisk=id pdisk=<PDISKID> assign=<yes | no>
action=deletevdisk controller=id vdisk=id [force=yes]
action=reconfigure controller=id vdisk=id raid=<c | r0 | r1 | r1c | r5 | r10> pdisk=<PDISKID>
[size=<size> vdcapacityexpansion=yes sizeinpercent=<1 to 100>]
action=securevd controller=id vdisk=id
action=clearvdbadblocks controller=id vdisk=id
ction=changepolicy controller=id vdisk=id [readpolicy=<ra | nra | ara | rc | nrc> | writepolicy=<wb | wt
| wc | nwc | fwb> | cachepolicy=<d | c> diskcachepolicy=<enabled | disabled>]
action=replacememberdisk controller=id vdisk=id source=<PDISKID> destination=<PDISKID>
action=rename controller=id vdisk=id
action=enablefluidcache controller=id vdisk=id devicename=<string> cachepolicy=<wb | wt>
action=disablefluidcache controller=id vdisk=id devicename=<string>
action=reactivate controller=id vdisk=id devicename=<string>
Omconfig Check Consistency
Table 132. omconfig Check Consistency
Description
Initiates a check consistency on a virtual disk. The check consistency task verifies the virtual disk’s
redundant data.
Syntax omconfig storage vdisk action=checkconsistency controller=id vdisk=id, where
id is the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage vdisk controller=ID to display the IDs
for the virtual disks attached to the controller.
Example to Run a check consistency on virtual disk 4 on controller 1.
Example
omconfig storage vdisk action=checkconsistency controller=1 vdisk=4
Omconfig Pause Check Consistency
Table 133. omconfig Pause Check Consistency
Description
Pauses a check consistency while in progress. For more information, see the Dell EMC
OpenManage Online Help.
Syntax
omconfig storage vdisk action=pausecheckconsistency controller=id
vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage vdisk controller=ID to display
the IDs for the virtual disks attached to the controller.
Example to Pause a check consistency on virtual disk 4 on controller 1
Example
omconfig storage vdisk action=pausecheckconsistency controller=1
vdisk=4
Omconfig storage commands 143