CLI Guide

Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
controller=0 enclosure=2 info=temps
index=1
Omreport Fan Status
The following table describes the syntax for the omreport Fan commands:
Table 98. omreport Fan Status
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id enclosure=<ENCLOSUREID>
info=fans where id is the controller number
and ENCLOSUREID is the enclosure
number. For example: controller=0
enclosure=2
NOTE: For SCSI controllers, the ID
specified in
enclosure=<ENCLOSUREID> is the
connector number and for Serial
Attached SCSI (SAS) controllers, ID
is the
connectorNumber:EnclosureIndex.
Displays the fans for the specified enclosure.
controller=id enclosure=<ENCLOSUREID>
info=fans index=n where id is the controller
number and ENCLOSUREID is the enclosure
number and n is the number of a fan. For
example: controller=0 enclosure=2 info=fans
index=1
Displays the specified fan.
Omreport Power Supply Status
The following table describes the syntax for the omreport Power Supply commands:
Table 99. Omreport Power Supply Commands
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id enclosure=<ENCLOSUREID>
info=pwrsupplies where id is the controller
number and ENCLOSUREID is the enclosure
number. For example: controller=0
enclosure=2
Displays the power supplies for the specified
enclosure.
controller=id enclosure=<ENCLOSUREID>
info=pwrsupplies index=n where id is the
controller number and ENCLOSUREID is the
enclosure number and n is the number of a
power supply. For example: controller=0
enclosure=2 info=pwrsupplies index=1
Displays the specified power supply.
128 Omreport storage commands