CLI Guide

Syntax Of Command Elements
The omreport and omconfig commands have multiple name=value pairs. These name=value pairs may include required, optional, and
variable parameters. The following table describes the syntax used to indicate these parameters.
Table 91. Syntax For Name=Value Pairs
Syntax Description
controller=id
Indicates the controller ID as reported by the omreport storage controller
command. To obtain these values, type omreport storage controller to
display the controller IDs and then type omreport storage pdisk
controller=id to display the IDs for the physical disks attached to the
controller.
For example, the controller=id parameter is specified as controller=1.
connector=id
Indicates the connector ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs
and then type omreport storage connector controller=id to display
the IDs for the connectors attached to the controller.
For example, the connector=id parameter is specified as connector=2.
vdisk=id
Indicates the virtual disk ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=id to display the
IDs for the virtual disks on the controller.
For example, the vdisk=id parameter is specified as vdisk=3.
enclosure=<ENCLOSUREID>
Indicates a particular enclosure by specifying either enclosure=connector
or enclosure=connector:enclosureID.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage enclosure
controller=id to display the IDs for the enclosures attached to the controller.
pdisk=<PDISKID>
Indicates a particular physical disk by specifying either connector:targetID
or connector:enclosureID:targetID.
To obtain the values for the connector, enclosure, and physical disk (targetID),
type omreport storage controller to display the controller IDs and then
type omreport storage pdisk controller=id to display the IDs for the
physical disks attached to the controller.
battery=id
Indicates the battery ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs
and then type omreport storage battery controller=id to display
the ID for the controller battery.
< >
The caret symbols (< >) enclose variable elements that you must specify.
For example, the name=<string>parameter is specified as
name=VirtualDisk1.
[ ]
The bracket symbols ([ ]) indicate optional elements that you can choose whether
or not to specify.
For example, when creating a virtual disk, the [name=<string>] parameter
indicates that you have the option of specifying the virtual disk name. If you omit
this parameter from the syntax, then a default name for the virtual disk is chosen
for you.
|
The pipe symbol (|) separates two or more options from which only one is
selected.
Using The Storage Management Service 123