Install Guide

Congure the SNMP agent to change the community name, enable set operations, and send traps to a management station. To congure
the SNMP agent for proper interaction with management applications, perform the procedures described in the Dell EMC OpenManage
Server Administrator User’s Guide.
Related Links:
• Installation Requirements
• Supported Systems Management Protocol Standards
Remote Enablement Requirements
The Remote Enablement feature is currently supported on:
• Red Hat Enterprise Linux
• SUSE Enterprise Linux
• VMware vSphere (ESXi)
Dependent RPMs For Remote Enablement
If you choose to install the Remote Enablement feature, you have to install certain dependent RPMs and congure these RPMs before
installing the feature. Install the following RPMs:
• libcmpiCppImpl0
• libwsman1 (RHEL)
• libwsman3 (SLES15)
• openwsman-server
• sblim-sfcb
• sblim-sfcc
NOTE
: Make sure that Pegasus RPMs are uninstalled.
Post Installation Conguration For Remote Enablement
This section details the steps to congure the dependent RPMs if you have installed the Remote Enablement feature.
The post-installation conguration script is available at /opt/dell/srvadmin/etc/ on the server le system.
After installing all the dependent RPMs and the Remote Enablement feature, execute the autoconf_cim_component.sh script.
Before executing the autoconf_cim_component.sh script, make sure that Systems Management is installed.
Execute the following command to congure sfcb and openwsman as per the default congurations: ./
autoconf_cim_component.sh
NOTE
: To congure openwsman on the managed node to run on a dierent port, use the -p < port > option with
autoconf_cim_component.sh. This is optional and by default the openwsman is congured to run on port 443.
12 Preinstallation Setup