Release Notes

• JIT-109207: Server Administrator displays incorrect capacity information of the drive when formatted with 4096 block size.

• JIT-111297: On Software RAID controller, Storage Management does not allow to expand the rst Virtual Disk to maximum available

drive space, if multiple the Virtual Disks are created on the same set of disks.

Installation Prerequisites

Storage Management does not display controllers and their features on systems that do not meet the driver and rmware requirements. At

Storage Management runtime, you can determine whether the system meets the rmware requirement or not, by checking the application

log les for notications on outdated rmware. At runtime, On SCSI controllers, Storage Management displays the rmware version at

runtime while on SAS controllers it displays the rmware and driver versions.

Installation Procedure

For complete installation instructions, see the Dell EMC OpenManage Server Administrator version Installation Guide.

This section provides information to enhance your experience with Server Administrator implementations and environments.

• Port 1311 is the default port for Server Administrator. It is a registered port number of Server Administrator. If another application is

congured to run on port 1311 before Server Administrator is installed, the DSM SA Connection Service does not start after installation.

Before you install Server Administrator, make sure that the port 1311 is not in use.

• Before starting Server Administrator, you must enable the client-side scripting in Internet Explorer.

To do so, perform the following:

a In Internet Explorer, navigate to the Tools menu.

b Click Internet Options.

c Click the Security tab.

d Select the security zone to which the system running Server Administrator belongs.

NOTE

: This option should be set to Trusted sites.

e Click the Custom Level button.

f For Windows 2003, perform the following:

1 In Miscellaneous, select the Allow META REFRESH radio button.

2 In Active Scripting, select the Enable radio button.

3 Under Active scripting, select the Allow scripting of Microsoft web browser controls radio button.

g Click OK and restart your browser.

• To allow Single Sign-on for Server Administrator, perform the following steps:

a In Internet Explorer, navigate to Tools.

b Click Internet Options.

c Click the Security tab.

d Select Trusted sites.

e Click the Custom Level button.

f Under User Authentication, select the Automatic Logon with current username and passwordradio button. Click OK to exit the

Custom Level window.

g Select the Advanced tab and in HTTP 1.1 settings, make sure Use HTTP 1.1 is checked.

h Select Trusted sites. Click Sites. Add the server to the website.

i Click Close.

j Click OK and restart your browser.

Dell EMC OpenManage Release Notes

Version 9.2.1