Users Guide

To locate Set Rebuild Rate In Storage Management
1 Expand the Storage tree object to display the controller objects.
2 Select a controller object.
3 Click Information/Conguration.
4 Select Set Rebuild Rate from the Available Tasks drop-down menu.
5 Click Execute.
You can also locate this task from the Change Controller Properties drop-down menu.
Resetting The Controller Conguration
Does my controller support this feature? See Supported Features.
The Reset Conguration task allows you to erase all the information on the controller so that you can perform a fresh conguration. This
operation destroys all data and virtual disks on the controller and unassigns any hot spares.
You must completely recongure the storage after performing this reset operation.
CAUTION: Resetting a conguration permanently destroys all data on all virtual disks attached to the controller. If the system or
boot partition resides on these virtual disks, it is destroyed.
NOTE: Resetting the controller conguration does not remove a foreign conguration. To remove a foreign conguration, select
Clear Foreign Conguration task.
NOTE: This task is not supported on PERC hardware controllers running in HBA mode.
Related link
Reset The Controller Conguration
To Locate Reset Conguration In Storage Management
Changing The Controller Properties
Reset The Controller Conguration
To reset the controller conguration:
1 Review the virtual disks that are destroyed by resetting the controller conguration. Make backups as necessary. Click Blink at the
bottom of the page to blink the physical disks included in the virtual disks.
2 Click Reset Conguration when you are ready to erase all information on the controller.
To exit without resetting the controller conguration, click Go Back to Previous Page.
To Locate Reset Conguration In Storage Management
1 In the Server Administrator window, under the system tree, expand Storage to display the controller objects.
2 Select a controller object.
3 Click Information/Conguration.
4 Select Reset Conguration from the Available Tasks drop-down menu.
5 Click Execute.
You can also locate this task from the Change Controller Properties drop-down menu.
62
Controllers