Users Guide

Resuming A Check Consistency

Does my controller support this feature? See Supported Features.

The Resume Check Consistency task resumes a check consistency after it has been paused.

Blinking And Unblinking A Virtual Disk

Does my controller support this feature? See Supported Features.

The Blink and Unblink tasks blink or unblink the lights on the physical disks included in the virtual disk.

NOTE: The blink operation is available only for removable disks.

Renaming A Virtual Disk

Does my controller support this feature? See Supported Features.

The Rename task enables you to change name of the virtual disk.

Related link

Renaming A Virtual Disk

Canceling A Rebuild

Does my controller support this feature? See Supported Features.

Select the Cancel Rebuild task to cancel a rebuild that is in progress. If you cancel a rebuild, the virtual disk remains in a Degraded state.

The failure of an additional physical disk can cause the virtual disk to fail and may result in data loss. It is recommended that you rebuild the

failed physical disk as soon as possible.

NOTE

: If you cancel the rebuild of a physical disk that is assigned as a hot spare, reinitiate the rebuild on the same physical disk

in order to restore the data. Canceling the rebuild of a physical disk and then assigning another physical disk as a hot spare does

not cause the newly assigned hot spare to rebuild the data. Reinitiate the rebuild on the physical disk that was the original hot

spare.

Changing The Virtual Disk Policy

Does my controller support this feature? See Supported Features.

The Change Policy task enables you to change the read, write, or cache policy of a virtual disk. Changes to the read, write, and cache

policy only apply to the virtual disk that you have selected. This task does not change the policy for all virtual disks on the controller.