Users Guide

Table 9. Controller Properties
Property Denition
ID Displays the ID assigned to the controller by Storage Management.
Storage Management numbers the controllers attached to the
system starting with zero. This number is the same as the controller
ID number reported by the omreport CLI Command. For
information on Command Line Interface, see the Server
Administrator Command Line Interface User’s Guide.
Status These icons represent the severity or health of the storage
component.
For more information, see Storage Component Severity.
• — Normal/OK
• — Warning/Non-critical
• — Critical/Failure/Error
Name Displays the name of the controller.
NOTE: For PowerEdge MX740c and MX840c having
PERC H745P mapped with MX5016s, the storage
controller name is displayed as PERC H745P MX
(MEZZANINE 1C)
Slot ID Displays the slot to which the controller is attached. For PowerEdge
FD332 storage sled, the name is displayed as: H745P MX and HBA
330 MMZ (MEZZANINE 1C).
NOTE: You can also identify the slot ID by selecting the
System > Main > System Chassis > Slots object and
clicking the Information tab.
State Displays the status of the controller. Possible values are:
• Ready — The controller is functioning normally.
• Degraded — The controller has encountered a failure and is
operating in a degraded state.
• Failed — The controller has encountered a failure and is no
longer functioning.
Firmware Version Displays the version of the rmware that is installed on the
controller.
NOTE: Storage Management displays Not Applicable on
some controllers for which the rmware version cannot be
obtained.
Minimum Required Firmware Version Displays the minimum rmware version that is required by Storage
Management. This property is displayed only if the controller
rmware does not meet the minimum requirement.
Driver Version Displays the version of the driver that is installed on the controller.
46 Controllers