Users Guide
• Backup operation completes without error. This indicates that there are no bad blocks on the written portion of your virtual disk.
If you still receive bad block warnings, the bad blocks are in a non-data area. Proceed to step 2.
2 Run Patrol Read and check the system event log to ensure that no new bad blocks are found.
If bad blocks still exist, proceed to step 3. If not, the condition is cleared without the need for step 3.
3 To clear these bad blocks, execute the Clear Virtual Disk Bad Blocks task.
This Clear Virtual Disk Bad Block feature is applicable to PERC H730P MX and PERC H745P MX.
Virtual Disk Properties And Tasks
Use the virtual disk properties and tasks window to view information about the virtual disks and execute virtual disk tasks.
From the Options menu:
Refresh Partitions: Click to refresh the Virtual Disk Partitions data once the partition is created using the operating system commands for
the available virtual disks.
Go to the Create Virtual Disk Wizard: Launches the Create Virtual Disk Wizard.
Virtual Disk Properties
The virtual disk properties can vary depending on the model of the controller.
Table 27. Virtual Disk Properties
Property Denition
Status These icons represent the severity or health of the storage component.
— Normal/OK
— Warning/Non-critical
— Critical/Failure/Error
For more information, see Storage Component Severity.
Name Displays the virtual disk name.
State Displays the status of the virtual disk. Possible values are:
• Ready — The virtual disk is functioning normally.
• Degraded — A physical disk in a redundant virtual disk is not online.
• Resynching — A consistency check is being performed on the virtual disk.
Performing a Cancelling A Check Consistency on a virtual disk while it is in Resynching
state causes the virtual disk to be in a Failed Redundancy state.
• Resynching Paused — A consistency check has been paused on the virtual disk.
• Regenerating — A physical disk in the virtual disk is rebuilding.
• Reconstructing — The virtual disk conguration has changed. The physical disks
included in the virtual disk are being modied to support the new conguration.
• Failed — The virtual disk has encountered a failure of one or more components and is
no longer functioning.
• Failed Redundancy — This state is displayed when the initial consistency check for the
virtual disk is canceled or is not successful. This state may also be displayed when a
112 Virtual Disks