Install Guide

4 Check for the required dependencies for the openwsman and sfcbd RPMs listed in the following table.
Table 3. Required Dependencies
Packages Red Hat Enterprise Server SUSE Linux Enterprise Server
Openwsman OpenSSL
LibXML
Pkgcong
CURL
Chkcong
Initscript
SBLIM-SFCC
LibOpenSSL
LibXML
Pkg-cong
libCURL
aaa_base
aaa_base
SBLIM-SFCC
SBLIM SFCC CURL LibCURL
SBLIM SFCB zlib
CURL
PAM
OpenSSL
Chkcong
Initscript
zlib
LibCURL
PAM
LibOpenSSL
aaa_base
aaa_base
5 Install the dependent RPMs. You can install the RPMs:
• with a single command rpm -ivh rpm1 rpm2 rpm3 rpm4 … rpmN
or
• individually
NOTE
: If you are installing RPMs individually, follow this sequence.
rpm -ivh sblim-sfcb-x.x.x.rpm
rpm -ivh sblim-sfcc-x.x.x.rpm
NOTE
: Install the libwsman and openwsman client RPMs simultaneously as they have cyclic dependency.
rpm -ivh libwsman1-x.x.x.rpm openwsman-client-x.x.x.rpm
rpm -ivh openwsman-server-x.x.x.rpm
Post Installation Conguration For Remote Enablement
This section details the steps to congure the dependent RPMs if you have installed the Remote Enablement feature.
The post-installation conguration script is available at /opt/dell/srvadmin/etc/ on the server le system.
After installing all the dependent RPMs and the Remote Enablement feature, execute the autoconf_cim_component.sh script.
NOTE
: The Distributed Web Server (DWS) connection does not work properly, if you have installed the sblim-sfcb RPM from
SUSE Linux Enterprise Server 11 SP3 operating system DVD. To resolve the connection issue, you must install the sblim-sfcb
RPM either from SUSE Linux Enterprise Server 11 SP2 operating system DVD or from the Dell EMC OpenManage Systems
Management Tools and Documentation software.
Before executing the autoconf_cim_component.sh script, make sure that Systems Management is installed.
Execute the following command to congure sfcb and openwsman as per the default congurations: ./
autoconf_cim_component.sh
NOTE
: To congure openwsman on the managed node to run on a dierent port, use the -p < port > option with
autoconf_cim_component.sh. This is optional and by default the openwsman is congured to run on port 443.
Preinstallation Setup 13