Connectivity Guide

Description Line Item Explanation
Memory device: DIMM_1B Serial number: 22222222
<Additional power supply
status information>
Species any additional power supply information pertaining to the event, for example:
Power supply input AC is off, Power supply POK (power OK) signal
is not normal, Power supply is turned off
Battery sensor status:
<status>
Species the status reported by the battery sensor, for example:
Battery sensor status: Predictive failure
Chassis intrusion state:
<Intrusion state>
Species the chassis intrusion state (open or closed), for example:
Chassis intrusion state: Open
Chassis location: <Name of
chassis>
Species the name of the chassis that generated the message, for example:
Chassis location: Main System Chassis
Configuration error type:
<type of configuration
error>
Species the type of conguration error that occurred, for example:
Configuration error type: Revision mismatch
Current sensor value (in
Amps): <Reading>
Species the current sensor value in amps, for example:
Current sensor value: 7.853
Date and time of action:
<Date and time>
Species the date and time that an automatic server recovery action was performed, for
example:
Date and time of action: Fri May 30 23:55:44 2003.
Description: <Description
of event>
Species the description of the event that occurred, for example:
Description: Chipset Err: Critical Event sensor, front panel NMI /
diagnostic interrupt was asserted.
Device location: <Location
in chassis>
Species the location of the device in the specied chassis, for example:
Device location: Mem Card A
Discrete current state:
<State>
Species the state of the current sensor, for example:
Discrete current state: Good
Discrete temperature state:
<State>
Species the state of the temperature sensor, for example:
Discrete temperature state: Good
Discrete voltage state:
<State>
Species the state of the voltage sensor, for example:
Discrete voltage state: Good
Fan sensor value: <Reading>
Species the fan speed in revolutions per minute (RPMs) or On/O, for example:
Fan sensor value (in RPM): 2600
Fan sensor value: Off
Log type: <Log type>
Species the type of hardware log, for example:
Log type: Embedded Server Management (ESM)
Memory device bank
location: <Bank name in
chassis>
Species the name of the memory bank in the system that generated the message, for
example:
462 SNMP Traps