CLI Guide

Usage of Extipmiusergroup
The following table displays the usage of extipmiusergroup=custom:
Table 56. Usage Of extipmiusergroup
name=value pair 1 name=value pair 2 name=value pair 3 Description
cong=user
id=user id
extipmiusergroup=custom
NOTE: extipmiusergroup
user group is available
only on the Dell 10G
blade systems.
id=user id
loginidrac=true | false true or false: Enables or disables
logging into iDRAC.
congureidrac=true | false true or false: Enables or disables
conguration of iDRAC.
Omcong Chassis Temps Or Omcong Mainsystem Temps
Use the omcong chassis temps or omcong mainsystem temps command to set warning thresholds for temperature probes. As with
other components, you can view both warning and failure threshold values, but you cannot set failure threshold values. The system
manufacturer sets the minimum and maximum failure threshold values.
NOTE
: Threshold values that you can set vary from one system conguration to another.
Valid Parameters For Temperature Warning Thresholds
The following table displays the valid parameters for setting temperature warning thresholds:
Table 57. Valid Parameters For
Omcong Chassis Temps Or Omcong Mainsystem Temps
name=value pair Description
index=<n> Number of the probe or probe index (specify).
warnthresh=default Sets the minimum and maximum warning threshold values to default.
minwarnthresh=<n> Sets the minimum warning threshold values (one decimal place).
maxwarnthresh=<n> Sets the maximum warning threshold values (one decimal place).
Setting Minimum And Maximum Warning Threshold Values
To set both the upper and lower temperature warning threshold values to the recommended default value, type:
omconfig chassis temps index=0 warnthresh=default
or
omconfig mainsystem temps index=0 warnthresh=default
Omcong
Managing Components Using The Instrumentation Service 93