CLI Guide

Group name=value pair 1 attribute= name=value pair 2 setting=
NOTE: The option is not supported
on Dell PowerEdge 13G and later
systems.
attribute=TcmClear
NOTE: The option is not supported
on Dell PowerEdge 13G and later
systems.
CAUTION: Clearing the TCM will
cause loss of all keys in the TCM.
This could aect booting of the
operating system.
setting=Yes | No
attribute=TcmSecurity
NOTE: The option is not supported
on Dell PowerEdge 13G and later
systems.
setting=O | OnPbm | OnNoPbm
attribute=SecureBoot
NOTE: The option is supported only
on 13G and later systems.
setting=Enabled | Disabled
attribute=SecureBootPolicy
NOTE: The option is supported only
on 13G and later systems.
setting=Enabled | Disabled
attribute=UeVariableAccess setting=Standard | Controlled
UEFI Boot Settings attribute=UeBootSeq sequence=aliasname1, aliasname2,.....
aliasnameN
Omcong Chassis Currents Or Omcong Mainsystem Currents
NOTE
: This command is no longer available through Server Administrator.
Omcong Chassis Fans Or Omcong Mainsystem Fans
Use the omcong chassis fans or omcong mainsystem fans command to set fan probe warning thresholds. As with other components,
you can view both warning and failure threshold values, but you cannot set failure thresholds. The system manufacturer sets the minimum
and maximum failure thresholds.
Valid Parameters For Fan Warning Thresholds
The following table shows the valid parameters for setting fan warning thresholds:
Table 47.
omcong chassis fans or omcong chassis fans
name=value pair Description
index= <n> Number of the probe or probe index (must specify).
warnthresh=default Sets minimum and maximum warning thresholds to default.
Omcong Managing Components Using The Instrumentation Service 77