CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=uausb setting=on | backonly | o
• on: Enables the user-accessible USB
port(s).
• backonly: Enables only the user-
accessible USB port(s) located at the
back of the system.
• o: Disables the user-accessible USB
port(s).
attribute=usb setting=enabled | disabled
• enabled: Enables the USB port(s).
• disabled: Disables the USB port(s).
NOTE: Depending on the system's
hardware you can congure either
usb or usbb.
attribute=usbb setting=enabled | enabledwithbios | disabled
• enabled: Enables the USB port(s) during
system boot, without BIOS support.
• enabledwithbios: Enables the USB
port(s) during system boot, with BIOS
support.
• disabled: Disables the USB port(s)
during system boot.
NOTE: Depending on the system's
hardware you can congure either
usb or usbb.
attribute=cstates setting=enabled | disabled
• enabled: Enables the processor to go
into a deep sleep state when the system
is not utilized.
• disabled: Disables the processor from
going into a deep sleep state when the
system is not utilized.
BIOS setup settings
The following table lists the BIOS setup attributes supported on PowerEdge systems. The attributes are grouped based on the hardware
conguration. The possible attributes may vary in a specic group. The omcong chassis biossetup command does not display the read-
only attributes.
NOTE
: If you have congured the setup password, then, always set the same password when you congure any BIOS settings.
Table 46. BIOS Setup Settings on PowerEdge systems
Group name=value pair 1 attribute= name=value pair 2 setting=
BIOS Option Settings attribute=BootSeq sequence=aliasname1, aliasname2,.....
aliasnameN
attribute=HddSeq sequence=aliasname1, aliasname2,.....
aliasnameN
Boot Settings attribute=BootMode setting=Bios | Ue
attribute=BootSeqRetry setting=Enabled | Disabled
70 Omcong Managing Components Using The Instrumentation Service