CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=bootmode setting=ue | bios
• ue: Enables the system to boot to
operating systems that support Unied
Extensible Firmware Interface (UEFI).
• bios: Enables the system to boot to
operating systems that do not support
UEFI.
attribute=bootorder sequence=aliasname1, aliasname2,.....
aliasnameN
Congures the boot sequence according to
the set aliasnames. To view the set alias
names, run the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=hddorder sequence=aliasname1, aliasname2,.....
aliasnameN
Congures the BIOS setup hard disk
sequence according to the set aliasnames.
Changes takes eect after rebooting the
system. To view the set alias names, run the
command omreport chassis
biossetup attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=cstates setting=enabled | disabled
• enabled: Enables the processor to go
into a deep sleep state when the system
is not utilized.
• disabled: Disables the processor to go
into a deep sleep state when the system
is not utilized.
attribute=conredirect setting=enabled | disabled
• enabled: Redirects the BIOS screen
output over serial port 1. Keyboard and
text output are redirected over serial port
2.
• disabled: Turns o the BIOS console
redirection.
attribute=cpucle setting=enabled | disabled
• enabled: Enables processor C1-E after
system reboot.
• disabled: Disables processor C1-E after
system reboot.
Omcong Managing Components Using The Instrumentation Service 63