CLI Guide

• Voltage Failure
• Processor Warning
• Processor Failure
• Hardware Log Warning
• Hardware Log Full
• Watchdog Asr
• Storage System Warning
• Storage System Failure
• Storage Controller Warning
• Storage Controller Failure
• Physical Disk Warning
• Physical Disk Failure
• Virtual Disk Warning
• Virtual Disk Failure
• Enclosure Warning
• Enclosure Failure
• Storage Controller Battery Warning
• Storage Controller Battery Failure
• Removable Flash Media Present
• Removable Flash Media Removed
• Removable Flash Media Failure
NOTE
: Storage Controller Battery Warning and Storage Controller Battery Failure events are not available on blade systems.
NOTE: System Power Probe Warning is not applicable to blade systems.
Omreport System Assetinfo Or Omreport Servermodule
Assetinfo
Use the omreport system assetinfo or omreport servermodule assetinfo command to see cost of ownership data for the system, such as
acquisition, depreciation, and warranty information. To set any of these elds, use the omcong system assetinfo or omcong servermodule
assetinfo command. For more information, see Omcong System Or Servermodule Assetinfo Editing Cost Of Ownership Values.
Omreport system events or omreport servermodule events
Use the omreport system events or omreport servermodule events command to view the currently enabled or disabled SNMP traps. Type:
omreport system events
or
omreport servermodule events
This command displays a summary of each component in the system for which events are generated. For each component, the report
shows which severities are set to report and which severities are set not to report. The following is an example output for a few
components:
Current SNMP Trap Configuration
-----------
System
-----------
Settings
44
omreport Viewing System Status Using The Instrumentation Service