CLI Guide

NOTE: On servers in the Dell PowerEdge FX2 series chassis, this command is supported only if the Chassis Management at
Server Mode is set to either Monitor or Manage and Monitor in the CMC, and Server Administrator displays the Chassis
Management at Server Mode as Enabled. For more details, see Chassis Management.
Omreport Chassis Volts Or Omreport Mainsystem Volts
Use the omreport chassis volts or omreport mainsystem volts command to view properties of the system’s voltage probes. Type:
omreport chassis volts index=n
or
omreport mainsystem volts index=n
The index parameter is optional. If you do not specify the index, Server Administrator displays a summary of status, readings, and
thresholds set for any voltage probes that are present on the system. If you specify the index, Server Administrator displays a summary for
a specic voltage probe.
Omreport Licenses
Use the omreport licenses command to view the digital licenses of the hardware devices installed on the system. Type:
omreport licenses
The following is an example output from the omreport licenses command:
Table 32.
omreport licenses command
Device Index : 0
Device Status : Ok
Device : iDRAC7
Device Description : iDRAC
Device ID : xxxx
License Index : 0
Description : iDRAC7 Enterprise Evaluation License
Status : OK
Recommended Action : N/A
License Type : Evaluation
EntitlementID : xxxx
Expiry Date : yyyy-mm-dd hh:mm:ss
Omreport System Commands Or Omreport
Servermodule Commands
Use the omreport system or omreport servermodule commands to view logs, threshold values, cost of ownership information, and
information about how shutdown actions and recovery actions are congured.
omreport Viewing System Status Using The Instrumentation Service
41