Manualshelf

CLI Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Server Administrator Version 9.1.2
21222324252627282930
NOTE: If iDRAC is installed, Server Administrator displays the Lifecycle Controller version. If BMC is installed, Server
Administrator displays the Unied Server Congurator (USC) version.
Omreport Chassis Frontpanel Or Omreport Mainsystem
Frontpanel
Use the omreport chassis frontpanel or omreport mainsystem frontpanel command to view if the front panel button control settings, such
as the Power button and/or Nonmasking Interrupt (NMI) button (if present on the system), are enabled or disabled.
If the Power button override is present on the system, check whether the Power button override is enabled or not. If enabled, the Power
button turns the power to the system On and O.
If the NMI button is present on the system, check whether the NMI button is enabled or not. Use the NMI button to troubleshoot software
and device errors when using certain operating systems.
The Front Panel LCD Security Access displays if the front panel encryption access information is set to View, Modify, or Disable.
The Front Panel LCD Information displays information such as service tag, remote indication status, and so on.
Omreport Chassis Fru Or Omreport Mainsystem Fru
Use the omreport chassis fru or omreport mainsystem fru command to view FRU information. When you type:
omreport chassis fru
or
omreport mainsystem fru
Server Administrator displays a summary of the system’s FRU information. This information is available in the Server Administrator GUI,
SNMP, and Common Information Model and is primarily used to support troubleshooting activities.
Omreport chassis hwperformance or omreport mainsystem
hwperformance
Use the omreport chassis hwperformance or omreport mainsystem hwperformance command to view the status and cause for the
system’s performance degradation. When you type:
omreport chassis hwperformance
or
omreport chassis hwperformance
Server Administrator displays a summary of the system’s hardware performance degradation information.
NOTE
: This command is applicable only to selected Dell 10G systems that support PMBus.
Depending on the system’s conguration, you may notice the following output:
Table 14. System
conguration output
Hardware Performance
Index : 0
omreport Viewing System Status Using The Instrumentation Service 27