CLI Guide

Force write back writepolicy=fwb
No write cache writepolicy=nwc
Name
name=<string>
Use this parameter to specify a name for the virtual disk. For example:name=VirtualDisk1
spanlength
Use this parameter to specify the number of physical disks in each stripe. This parameter applies only to RAID-50 an RAID 60 and optional
for RAID 10 virtual disks. If you are not creating a RAID-50 virtual disk, do not specify this parameter. For example:
spanlength=3
For RAID 10 on SAS controllers with rmware version 6.1 and later, spanlength is optional. Also, you can now specify the spanlength as an
even number with a maximum of 8 spans with 32 physical disks each. For example:
omconfig storage controller action=createvdisk controller=1 raid=r10 size=min pdisk=
1:1:0,1:1:1,1:1:3,1:1:4,1:1:6,1:1:7,1:1:8,1:1:9
spanlength=4
Omcong Set Controller Rebuild Rate
Table 171.
Omcong Set Controller Rebuild Rate
Description
Sets the controller rebuild rate.
Syntax omconfig storage controller action=setrebuildrate controller=id rate=<0 to 100>, where
id is the controller ID as reported by the omreport storage controller command.
Example to Set the rebuild rate to 50 on controller 1.
Example
omconfig storage controller action=setrebuildrate controller=1 rate=50
omcong Change Controller Properties
Table 172.
omcong Change Controller Properties
Description
Changes any or all of the controller properties.
Syntax
omconfig storage controller action=
setchangecontrollerproperties controller=<id>
bgirate=<rate> reconstructrate=<rate>
checkconsistencyrate=<rate> rebuildrate=<rate>
clearredundantpath=clear
abortcheckconsistencyonerror=<enabled |
disabled> loadbalance=<auto | disabled>
allowrevertiblehotspareandreplacemember=<enable
d | disabled>
176 Omcong storage commands