CLI Guide

Required Command Levels (1, 2, 3) Optional name=value pairs
action=setpdiskpwrmanagement controller=id spindownuncongureddrives=<enabled/disabled>
spindownhotspares=<enabled/disabled> spindowncongureddrives=<enabled/disabled>
idlec=<enabled/disabled> spindowntimeinterval=<30 to 1440>(minutes)
spinupstarttime=<HH:MM:AM/PM> spinuptimeinterval=<1 to 24>(hours)
NOTE: Specify spinupstarttime and spinuptimeinterval only when you set
spindowncongureddrives=enabled.
action=setcontrollermode controller=id mode=<raid | hba>
action=autocongureRAID0 controller=id
action=setpatrolreadmode controller=id mode=<manual | auto | disable>
action=startpatrolread controller=id
action=stoppatrolread controller=id
action=createcachecade controller=id pdisk=<PDISKID> [name=<string>]
action=enablelkm controller=id keyid=<keyid> passphrase=<passphrase string> [escrow=yes]
[lepath=<Absolute path to the escrow le>]
NOTE: If you set escrow=yes, specify the escrow le
path.
action=switchtolkm controller=id keyid=<keyid> passphrase=<passphrase string> [escrow=yes]
[lepath=<Absolute path to the escrow le>]
NOTE: If you set escrow=yes, specify the escrow le
path.
action=rekeylkm controller=id
action=convertraidtononraid controller=id pdisk=<PDISKID>
action=convertnonraidtoraid controller=id pdisk=<PDISKID>
Omcong Rescan Controller
Table 152.
Omcong Rescan Controller
Description Rescans a controller. For more information, see the Dell EMC OpenManage Online Help .
Syntax omconfig storage controller action=rescan controller=id, where id is the controller
ID as reported by the omreport storage controller command.
Example to Rescan controller 1.
Example
omconfig storage controller action=rescan controller=1
NOTE: The rescan controller is not supported on non-RAID SCSI and SAS controllers. Reboot
the system to make the conguration changes visible on non-RAID SCSI controllers.
Omcong storage commands 167