CLI Guide

Omreport PCIe SSD Status
The following table describes the syntax for the omreport pciessd commands.
Table 105. omreport PCIe SSD Command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage pciessd
Displays the properties of the PCIe SSD
subsystem.
subsystem=id Displays the properties of the specied PCIe
subsystem.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 106. Omreport Storage Tape Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller number.
For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the specied
connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specied tape drive.
Omreport NVMe adapter
The following table describes the syntax for the omreport nvmeadapter commands.
Table 107. omreport NVMe adapter command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage nvmeadapter
Displays the properties of the NVMe
adapters.
controller=id, where id is the controller
number. For example, controller=0.
Displays the properties of all the NVMe
adapters on the specied controller.
controller=id, nvmeid=id, where id is the
controller number and the NVMe adapter
respectively. For example, controller=0
nvmeid=1.
Displays the properties of the specied
NVMe adapter on the specied controller.
Omreport storage commands 143