CLI Guide

You can type more than one omcong system assetinfo or omcong servermodule assetinfo command at the same time, as long as all of
the parameters for name=value pair 2 belong to the same name=value pair 1. For example, to type more than one parameter value for
info=acquisition, use the following example as a syntax guide:
omconfig system assetinfo info=acquisition purchasecost=5000
waybill=123456 installdate=120501 purchasedate=050601 ponum=9999 signauth="John Smith"
expensed=yes costcenter=finance
or
omconfig servermodule assetinfo info=acquisition purchasecost=5000 waybill=123456
installdate=120501 purchasedate=050601 ponum=9999 signauth="John Smith" expensed=yes
costcenter=finance
The following message is displayed:
Asset information set successfully.
Adding depreciation information
Depreciation is a set of methods for computing the devaluation of the asset over time. For example, the depreciation of a system that is
expected to have a useful life of 5 years is 20 percent. Use the omcong system assetinfo info=depreciation or omcong servermodule
assetinfo info=depreciation command to add details about how the system's depreciation is computed. The following table shows the valid
parameters for the command.
Table 79. Valid Parameters Of omcong system assetinfo info=depreciation or omcong servermodule assetinfo info=depreciation
Command Level 1 Command Level 2 Command Level 3 Name= Value Pair 1 Name= Value Pair 2 Description
omcong system or
servermodule
assetinfo info=depreciation duration=<n> Number of years or months
over which a system is
depreciated.
method=<text> Steps and assumptions used
to compute the system's
depreciation.
percent=<n> Portion of 100 that an asset
is devalued or depreciated.
unit=months | years Unit is months or years.
Example command for adding depreciation information
To provide a value for a depreciation parameter, type a command of the form: omcong system assetinfo info=depreciation <name=value
pair 2> or omcong servermodule assetinfo info=depreciation <name=value pair 2>. For example, type:
omconfig system assetinfo info=depreciation method=straightline
or
omconfig servermodule assetinfo info=depreciation method=straightline
The following message is displayed:
Asset information set successfully.
You can type more than one omcong system assetinfo or omcong servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see Example Commands For Adding Acquisition
Information.
124
Omcong System Or Servermodule Assetinfo Editing Cost Of Ownership Values