Users Guide

The Remote Access object action window can have the following tabs, depending on the user's group privileges:Properties,
Conguration, and Users.
Subtab: Information
Properties
Under the Properties tab, you can view general information on the remote access device. You can also view the attributes of the IPv4 and
IPv6 addresses.
Click Reset to Defaults to reset all the attributes to their system default values.
Subtabs: LAN | Serial Port | Serial Over LAN | Additional Conguration
Conguration
Under the Conguration tab when BMC/iDRAC is congured, you can congure the BMC/iDRAC on a LAN, serial port for BMC/iDRAC,
and BMC/iDRAC on a serial over LAN connection.
NOTE: The Additional conguration tab is available only on systems with iDRAC.
Under the Conguration tab, when DRAC is congured, you can congure network properties.
Under the Additional Conguration tab you can either enable or disable IPv4/IPv6 properties.
NOTE: Enabling/disabling IPv4/IPv6 is possible only in a dual stack environment (where both the IPv4 and IPv6 stacks are
loaded).
Users
Subtab: Users
Under the Users tab, you can modify the remote access user conguration. You can add, congure, and view information about Remote
Access Controller users.
Removable ash media
Click the Removable Flash Media object to view the health and redundancy status of the Internal SD Modules and vFlash media. The
Removable Flash Media action window has the Properties tab.
Properties
Subtab: Information
Under the Properties tab, you can view information about the Removable Flash Media and Internal SD Modules. This includes details about
the Connector Name, its state, and storage size.
Alert Management
Subtabs: Alert Actions | SNMP Traps
Under the Alert Management tab, you can:
View current alert actions settings and set the alert actions that you want to be performed when the removable ash media probe
returns a warning or failure value.
View current SNMP trap alert thresholds and set the alert threshold levels for removable ash media probes. The selected traps are
triggered if the system generates a corresponding event at the selected severity level.
52
Server Administrator services