CLI Guide

name=value pair 1
cong=
name=value pair 2 Description
dracnic: Enables DRAC NIC if DRAC 5 is installed.
NOTE: The nicselection option is supported only on
PowerEdge 10G and 11G systems. From PowerEdge
12G systems onwards, primarynw and failovernw
replaces nicselection.
primarynw=dedicated | lom1 | lom2 | lom3
| lom4
dedicated: Congures dedicated port as primary network
for remote access.
NOTE: This option requires license to congure
primarynw as dedicated. If the appropriate license is
not installed or has expired, the system displays an
error message. For more information, see Dell
License Manager at dell.com/openmanagemanuals.
lom 1: Congures lom1 port as the primary network for
remote access.
lom 2: Congures lom2 port as the primary network for
remote access.
lom 3: Congures lom3 port as the primary network for
remote access.
lom 4: Congures lom4 port as the primary network for
remote access.
NOTE: The primarynw option is supported from
PowerEdge12G systems onward. If the primarynw is
set to dedicated, then set failovernw to none.
NOTE: If the primarynw is set to dedicated, then set
failovernw to none.
failovernw=none | lom1 | lom2 | lom3 |
lom4 | all
none: Congures the failover network to none.
lom 1: Congures the failover network to lom 1.
lom 2: Congures the failover network to lom 2.
lom 3: Congures the failover network to lom 3.
lom 4: Congures the failover network to lom 4.
all: Congures the failover network to all loms.
NOTE: The failovernw option is supported on
PowerEdge12G systems onward. Congure both
primarynw and failovernw to set the nicselection.
The primarynw and failovernw options cannot have
the same value.
NOTE: Congure both primarynw and failovernw to
set the nicselection. The primarynw and failovernw
options cannot have the same value.
NOTE: Failovernw requires license to congure the
ports. If the appropriate license is not installed or
has expired, the system displays an error message.
For more information, see Dell License Manager at
dell.com/openmanagemanuals.
ipaddress=IP
Sets the IP address if you have selected static as the IP
address source for the BMC LAN interface.
79