CLI Guide

When you issue the command and the system sets the values you specify, the following message is displayed:
Power consumption probe warning threshold(s) set successfully.
Omcong chassis remoteaccess or omcong mainsystem remoteaccess
Use the omcong chassis remoteaccess or omcong mainsystem remoteaccesscommand to congure:
• Remote access on a local area network (LAN).
• The serial port for BMC or RAC, whichever is installed.
• The BMC or RAC on a serial over LAN connection.
• Terminal settings for the serial port.
• Advanced settings for a serial over LAN connection.
• Information on a BMC or RAC user.
• Information on IPv6 and IPv4 interfaces.
NOTE: Enter the user ID to congure user information.
Type:
omconfig chassis remoteaccess
or
omconfig mainsystem remoteaccess
The output of the omcong chassis remoteaccess or omcong mainsystem remoteaccess command lists each of the available
congurations. The following table displays the valid parameters:
Table 54. Valid Parameters Of Omcong Chassis Remoteaccess Or Omcong Mainsystem Remoteaccess
name=value pair 1
cong=
name=value pair 2 Description
cong=additional ipv4=enable | disable
enable: IPv4 stack to load on iDRAC.
disable: IPv4 stack to ush on iDRAC.
ipv6=enable | disable
enable: Enables IPv6 stack to load on iDRAC.
disable: Disables IPv6 stack to unload on iDRAC.
NOTE: This option requires license to enable or
disable ipv6. If the appropriate license is not
installed or has expired, the system displays an error
message. For more information, see Dell License
Manager at dell.com/openmanagemanuals.
cong=advsol characcuminterval=number
number: Sets the character accumulate interval in 5
millisecond intervals.
charsendthreshold=number
number: Sets the number of characters. BMC automatically
sends a serial over LAN data packet that contains the
number of characters as soon as this number of characters
(or greater) has been accepted from the baseboard serial
controller into the BMC.
enableipmi= true | false
true: Enables IPMI over LAN.
false: Disables IPMI over LAN.
enablenic=true | false
true: Enables DRAC NIC.
false: Disables DRAC NIC
nicselection=sharedwithfailoveronall | nic1
|teamednic1nic2 | dracnic
sharedwithfailoveronall: Congures the new NIC selection
option.
nic1: Enables NIC 1.
teamednic1nic2: Enables NIC teaming functionality.
78