CLI Guide

name=value pair 1 name=value pair 2 Description

NOTE: These options are applicable

only when a custom prole is

selected.

NOTE: Reboot the system for the power proles setup options to take eect.

Omcong Chassis Pwrmonitoring Or Omcong Mainsystem Pwrmonitoring

Use the omcong chassis pwrmonitoring or omcong mainsystem pwrmonitoring command to congure power consumption

information.

The following table displays the valid parameters for the command:

Table 53. Valid Parameters Of Omcong Chassis Pwrmonitoring Or Omcong Mainsystem Pwrmonitoring

name=value pair 1 name=value pair 2 Description

index=<n> NA Number of the probe or probe index (must

specify).

cong=probe warnthresh=settodefault Sets the minimum and maximum warning

thresholds values to default.

warnthresh=<n > Sets a value for the warning threshold.

unit=watt | btuphr

watt: Displays the unit in Watts.

btuphr: Displays the unit in BTU/hr.

cong=resetreading type=energy | peakpower

energy: Resets the system energy

reading.

peakpower: Resets the system peak

power.

NOTE: This command is applicable only on selected Dell 10G systems that support PMBus.

NOTE: Power monitoring requires license to congure the power budget information. If the appropriate license is not

installed or has expired, the system displays an error message. For more information, see

Dell License Manager

dell.com/openmanagemanuals.

Default warning thresholds

NOTE: Sensor managing capabilities vary across systems.

To set both the upper and lower power consumption probe warning threshold values to the recommended default value, type:

omconfig chassis pwrmonitoring config=probe index=0 warnthresh=settodefault

omconfig mainsystem pwrmonitoring config=probe index=0 warnthresh=settodefault

You cannot default one value and set another. If you default the minimum warning threshold value, you are also selecting the default

value for the maximum warning threshold value.

Specify A Value For Warning Thresholds

If you prefer to specify values for the power consumption probe warning thresholds, you must specify the number of the probe you

are conguring and the warning threshold value. Congure the values to display either in BTU/hr or Watts. In the following example,

the probe that is being congured is probe 4:

omconfig chassis pwrmonitoring config=probe index=4 warnthresh=325 unit=watt

omconfig mainsystem pwrmonitoring config=probe index=4 warnthresh=325 unit=btuphr