CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
• on: System is turned on.
delay=random | immediate | timedelay
<value>
• random: System is turned on with
random delay.
• immediate: System returns to previous
state immediately.
• timedelay < value >: System is turned
on based on the user specied time
delay.
attribute=bezel setting=enabled | disabled
• enabled: Enables the bezel removal
intrusion check during system boot.
• disabled: Disables the bezel removal
intrusion check during system boot.
attribute=bootsequence setting=disketterst | hdonly | devicelist |
cdromrst | opticaldrive
Instructs the BIOS which device is used to
boot the system, and the order in which
the boot routine checks each device.
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=bootmode setting=ue | bios
• ue: Enables the system to boot to
operating systems that support Unied
Extensible Firmware Interface (UEFI).
• bios: Enables the system to boot to
operating systems that do not support
UEFI.
attribute=bootorder sequence=aliasname1, aliasname2,.....
aliasnameN
Congures the boot sequence according
to the set aliasnames. To view the set alias
names, run the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=hddorder sequence=aliasname1, aliasname2,.....
aliasnameN
Congures the BIOS setup hard disk
sequence according to the set aliasnames.
Changes takes eect after rebooting the
system. To view the set alias names, run
the command omreport chassis
biossetup attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
56