CLI Guide

Read Policy readpolicy=ra | ara | nra | rc | nrc Parameter Specication
No read cache readpolicy=nrc
Writepolicy=<wb | wt | wc | nwc>
Dierent controllers support dierent write policies. The following table displays how to specify the writepolicy=<wb | wt | wc | nwc
| fwb> parameter for each of the write policies.
Table 170. Write Policy Parameters
Write Policy writepolicy=wb | wt | wc | fwb | nwc Parameter Specication
Write-back cache writepolicy=wb
Write-through cache writepolicy=wt
Write cache writepolicy=wc
Force write back writepolicy=fwb
No write cache writepolicy=nwc
name=<string>
Use this parameter to specify a name for the virtual disk. For example:name=VirtualDisk1
spanlength=<n> (Required For RAID 50 And RAID 60 And Optional For RAID 10)
Use this parameter to specify the number of physical disks in each stripe. This parameter applies only to RAID-50 virtual disks. If you
are not creating a RAID-50 virtual disk, do not specify this parameter. For example:
spanlength=3
For RAID 10 on SAS controllers with rmware version 6.1 and later, spanlength is optional. Also, you can now specify the spanlength
as an even number with a maximum of 8 spans with 32 physical disks each. For example:
omconfig storage controller action=createvdisk controller=1 raid=r10 size=min pdisk=
1:1:0,1:1:1,1:1:3,1:1:4,1:1:6,1:1:7,1:1:8,1:1:9
spanlength=4
Omcong Set Controller Rebuild Rate
Table 171. Omcong Set Controller Rebuild Rate
Description
Sets the controller rebuild rate.
Syntax omconfig storage controller action=setrebuildrate controller=id rate=<0 to 100>,
where id is the controller ID as reported by the omreport storage controller command.
Example to Set the rebuild rate to 50 on controller 1.
Example
omconfig storage controller action=setrebuildrate controller=1 rate=50
omcong Change Controller Properties
Table 172. omcong Change Controller Properties
Description
Changes any or all of the controller properties.
Syntax
omconfig storage controller action=
setchangecontrollerproperties controller=<id>
bgirate=<rate> reconstructrate=<rate>
checkconsistencyrate=<rate>
rebuildrate=<rate> clearredundantpath=clear
abortcheckconsistencyonerror=<enabled |
disabled> loadbalance=<auto | disabled>
allowrevertiblehotspareandreplacemember=<enab
152