CLI Guide

Table 101. omreport Battery Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage battery Displays all batteries present on all
controllers on the system (Some
controllers do not have batteries).
controller=id, where id is the controller
number. For example: controller=0
Displays the battery on the specied
controller.
controller=id battery=id, where id is the
controller number. For example:
controller=0
Displays the specied battery.
Omreport Global Information
The following table describes the syntax for the omreport Global Information commands:
Table 102. Omreport Global Information Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage globalinfo
Displays whether smart thermal shutdown
is enabled or disabled. For more
information, see Omcong Global Enable
Smart Thermal Shutdown.
Displays the hot spare protection policy
that you have set. For more information on
setting hot spare protection policy, see the
Dell EMC OpenManage Server
Administrator Storage Management User’s
Guide at dell.com/support/manuals.
Omreport Connector Status
The following table describes the syntax for the omreport Connector commands:
Table 103. omreport Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector
Displays all connectors present on all controllers
on the system.
NOTE: This command works only when
the controller ID is specied.
controller=id, where id is the
controller number. For example:
controller=0
Displays the connectors on the specied
controller.
controller=id connector=id, where id
is the connector number. For
example, connector=0
Displays the specied connector.
NOTE: When the connectors are
connected to the enclosure in redundant
path mode, the Name of the connector is
displayed as Logical Connector.
Omreport Cachecade Status
The following table describes the syntax for the omreport Cachecade commands
123