CLI Guide

Adding warranty information
Use the omcong system warranty or omcong servermodule warranty command to assign values for warranty information. A
warranty is a contract between the manufacturer or dealer and the purchaser of a system. The warranty identies the components
that are covered for repair or replacement for a specied length of time or usage. For details on editing extended warranty values,
see Adding Extended Warranty Information. The following table displays the valid parameters for adding warranty information.
Table 88. Valid Parameters Of omcong system assetinfo info=warranty Or omcong servermodule assetinfo info=warranty
Command
Level 1
Command
Level 2
Command
Level 3
Name= Value
Pair 1
Name= Value Pair 2 Description
omcong system or
servermodule
assetinfo info=warranty cost=<cost> Cost of the warranty
service.
duration=<duration> Number of days or months
that the warranty is in
force.
enddate=<enddate> Date the warranty
agreement ends.
unit=days | months Whether the number for
duration refers to days or
months.
Example command for adding warranty information
To provide a value for a warranty parameter, type a command of the form omcong system assetinfo info=warranty <name=value
pair 2> or omcong servermodule assetinfo info=warranty <name=value pair 2>. For example, type:
omconfig system assetinfo info=warranty unit=days
or
omconfig servermodule assetinfo info=warranty unit=days
The following message is displayed:
Asset information set successfully.
You can type more than one omcong system assetinfo or omcong servermodule assetinfo command at the same time, as long as
all the parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see Example Command For Adding
Acquisition Information.
115