CLI Guide

whether you want notication for event severity according to the number of the component by using the index=<n> parameter. The
following table displays the valid severity parameters.
Table 72. System Event Severity Parameters
Command Result Description
omcong system events
type=<component name> severity=info
or omcong servermodule events
type=<component name> severity=info
Enables notication for informational,
warning, and critical events.
Least restrictive form of event
notication.
omcong system events
type=<component name>
severity=warning or omcong
servermodule events type=<component
name> severity=warning
Enables notication for warning and
critical events.
Omits informational event notication, for
example, when a component returns to
normal status.
omcong system events
type=<component name>
severity=critical or omcong
servermodule events type=<component
name> severity=critical
Enables notication for critical events
only.
Restrictive form of event notication.
omcong system events
type=<component name> severity=none
or omcong servermodule events
type=<component name> severity=none
Disables event notication. No event notication.
Index
Index refers to the number of an event for a particular component. Index is an optional parameter. When you omit the index
parameter, events are congured for all components of the specied type, such as all fans. For example, when a system contains
more than one fan, you can enable or disable event notication for a particular fan. An example command is as follows:
omconfig system events type=fan index=0 severity=critical
or
omconfig servermodule events type=fan index=0 severity=critical
As a result of the example command, Server Administrator sends an SNMP trap only when the rst fan in the system chassis (index
0) has reached critical fan RPMs.
Omcong System Webserver Or Omcong Servermodule Webserver
Use the omcong system webserver or omcong servermodule webserver command to start or stop the Web server. The following
table displays the valid parameters for the command.
Table 73. Valid Parameters Of Web Server Conguration
name=value pair Description
action=start Starts the Web server.
action=stop Stops the Web server.
action=restart Restarts the Web server.
Omcong System Recovery Or Omcong Servermodule Recovery
Use the omcong system recovery or omcong servermodule recovery command to set the action when the operating system
hangs or crashes. You can also set the number of seconds that must pass before the system is considered to have a hung operating
system. The following table lists the valid parameters for the command
104