CLI Guide

Event Name Description
event=processorfail Sets action or enables or disables alert generation when a processor probe detects that
the processor has failed.
event=processorabsent Sets action or enables or disables alert generation when a processor probe detects that
the processor is absent.
event=redundegrad Sets action or enables or disables alert generation when the system fans and/or power
supplies become inoperative, resulting in less than full redundancy for that component.
event=redunlost Sets action or enables or disables alert generation when the system fans and/or power
supplies become inoperative, resulting in a lost or a no redundant components working
condition for that component.
event=systempowerwarn Sets actions when a power consumption probe detects a warning value.
event=systempowerfail Sets actions when a power consumption probe detects a failure value.
event=tempwarn Sets action or enables or disables alert generation when a temperature probe detects
that the temperature is approaching the maximum high or low limits.
event=removableashmediapresent Sets actions that Server Administrator performs when the system detects a removable
ash media.
event=removableashmediawarn Sets actions that Server Administrator performs when a removable ash media warning
is displayed.
event=removableashmediafail Sets actions that Server Administrator performs when a removable ash media fails.
event=tempfail Sets action or enables or disables alert generation when a temperature probe detects
that the temperature is either too high or low for proper operation.
event=voltfail Sets action or enables or disables alert generation when a voltage probe detects that the
voltage is too low for proper operation.
event=intdualsdcardcritical Sets actions that Server Administrator performs when an internal dual SD card critical
event occurs.
event=intdualsdcardwarn Sets actions that Server Administrator performs when an internal dual SD card warning is
displayed.
event=intdualsdcardabsent Sets actions that Server Administrator performs when an internal dual SD card is not
available.
event=intdualsdcardredunlost Sets actions that Server Administrator performs when the redundancy of an internal dual
SD card is lost.
event=watchdogasr Enables or disables alert generation congured by the ASR when the system has hung or
is not responding.
Omcong system snmptraptest or omcong servermodule snmptraptest
Use the omcong system snmptraptest or omcong servermodule snmptraptest command to send the snmp test trap to the
destination address if Server Administrator SNMP component is congured in the conguration le.
The following table displays the valid parameters for the command:
Table 70. Parameters For Alert Action Command
Action Description
dest=<ipv4 address |
ipv6 address | fqdn>
Send the test trap to the destination IP address.
NOTE: This feature is not supported on VMware ESXi.
102