Users Guide
Table 10. Controller Properties
Property Denition
ID Displays the ID assigned to the controller by Storage
Management. Storage Management numbers the controllers
attached to the system starting with zero. This number is the
same as the controller ID number reported by the omreport
CLI Command. For information on Command Line Interface, see
the Server Administrator Command Line Interface User’s Guide.
Status These icons represent the severity or health of the storage
component.
For more information, see Storage Component Severity.
• — Normal/OK
• — Warning/Non-critical
• — Critical/Failure/Error
Name Displays the name of the controller.
NOTE: For PowerEdge FD332 storage sled, the name is
displayed as:
• Single controller — PERC FD33xS (Integrated RAID
Controller <X> in Front Chassis Slot <Y>, where X
displays the controller number and Y displays the front
chassis slot number.
• Dual controller — PERC FD33xD (Integrated RAID
Controller <X> in Front Chassis Slot <Y>, where X
displays the controller number and Y displays the front
chassis slot number.
Slot ID Displays the slot to which the controller is attached. For
PowerEdge FD332 storage sled, the name is displayed as: PCI
Slot <Y> <X>, where Y displays the front chassis slot number
and X displays the controller number.
NOTE: You can also identify the slot ID by selecting the
System → Main → System Chassis → Slots object and
clicking the Information tab.
State Displays the status of the controller. Possible values are:
• Ready — The controller is functioning normally.
• Degraded — The controller has encountered a failure and is
operating in a degraded state.
• Failed — The controller has encountered a failure and is no
longer functioning.
Firmware Version Displays the version of the rmware that is installed on the
controller.
NOTE: Storage Management displays Not Applicable on
some controllers for which the rmware version cannot
be obtained.
52