Users Guide

NOTE: This command is not supported on SCSI RAID controllers.
Syntax
omconfig storage enclosure action=resetalltempprobes controller=id
enclosure=<ENCLOSUREID>, where id is the controller ID. The <ENCLOSUREID> variable
species the enclosure.
In this syntax, n is a user-specied alphanumeric string.
Example to Reset the thresholds for all temperature probes in enclosure 3 attached to connector 2 on controller
1.
Example for SAS
controllers
omconfig storage enclosure action= resetalltempprobes controller=1
enclosure=2:3
Omcong Blink
Table 202. omcong Blink
Description Blinks the light-emitting diodes (LEDs) on the enclosure.
Syntax
omconfig storage enclosure action=blink controller=id
enclosure=<ENCLOSUREID>, where id is the controller ID. The <ENCLOSUREID> variable
species the enclosure.
Example to Blink the LEDs for enclosure 3 attached to connector 2 on controller 1.
Example for SAS
controllers
omconfig storage enclosure action=blink controller=1 enclosure=2:3
Example for SCSI, SATA,
and ATA controllers
omconfig storage enclosure action=blink controller=1 enclosure=2
Omcong Battery Commands
The following table displays the omcong command syntax required to execute battery tasks.
Table 203. Omcong Battery Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omcong storage battery action=startlearn controller=id battery=id
action=delaylearn controller=id battery=id days=d hours=h
omcong Start Battery Learn Cycle
Table 204. Omcong Start Battery Learn Cycle
Description Starts the battery learn cycle.
Syntax omconfig storage battery action=startlearn controller=id battery=id,
where id is the controller ID and battery ID as reported by the omreport command. To obtain this
value, type
omreport storage controller to display the controller IDs and then type
omreport storage battery controller=ID to display the ID for the controller battery.
Example to Start the learn cycle on controller 1.
175