Users Guide

Required Command Levels (1, 2, 3) Optional name=value pairs Use
controller=id connector=id, where id
is the connector number. For
example, connector=0
Displays the specied connector.
NOTE: When the connectors are
connected to the enclosure in redundant
path mode, the Name of the connector is
displayed as Logical Connector.
Omreport Cachecade Status
The following table describes the syntax for the omreport Cachecade commands
Table 102. omreport Cachecade Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage cachecade Displays property information for all
cachecades on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all cachecades on the specied
controller.
controller=id cachecade=id, where id is the
controller number and the cachecade number.
For example, controller=0 cachecade=1.
Displays the specied cachecade on the
controller.
Omreport PCIe SSD Status
The following table describes the syntax for the omreport pciessd commands.
Table 103. omreport PCIe SSD Command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage pciessd
Displays the properties of the PCIe SSD
subsystem.
subsystem=id Displays the properties of the specied
PCIe subsystem.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 104. Omreport Storage Tape Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller
number. For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the specied
connector.
134