Users Guide

Related links
Rebuilding Redundant Information
To Change The Rebuild Rate
To locate Set Rebuild Rate In Storage Management
To Change The Rebuild Rate
To change the rebuild rate:
1. Type a numerical value in the Set New Rebuild Rate (0-100) eld. The value must be within the 0–100 range.
2. Click Apply Changes.
To exit and cancel your changes, click Return to Previous Page.
To locate Set Rebuild Rate In Storage Management
1. Expand the Storage tree object to display the controller objects.
2. Select a controller object.
3. Click Information/Conguration.
4. Select Set Rebuild Rate from the Available Tasks drop-down menu.
5. Click Execute.
You can also locate this task from the Change Controller Properties drop-down menu.
Resetting The Controller Conguration
Does my controller support this feature? See Supported Features.
The Reset Conguration task allows you to erase all the information on the controller so that you can perform a fresh conguration.
This operation destroys all data and virtual disks on the controller and unassigns any hot spares.
You must completely recongure the storage after performing this reset operation.
CAUTION: Resetting a conguration permanently destroys all data on all virtual disks attached to the controller. If the
system or boot partition resides on these virtual disks, it is destroyed.
NOTE: Resetting the controller conguration does not remove a foreign conguration. To remove a foreign conguration,
select Clear Foreign Conguration task.
NOTE: This task is not supported on PERC hardware controllers running in HBA mode.
Related links
Reset The Controller Conguration
To Locate Reset Conguration In Storage Management
Changing The Controller Properties
Reset The Controller Conguration
To reset the controller conguration:
1. Review the virtual disks that are destroyed by resetting the controller conguration. Make backups as necessary. Click Blink at
the bottom of the page to blink the physical disks included in the virtual disks.
2. Click Reset Conguration when you are ready to erase all information on the controller.
To exit without resetting the controller conguration, click Go Back to Previous Page.
To Locate Reset Conguration In Storage Management
1. In the Server Administrator window, under the system tree, expand Storage to display the controller objects.
2. Select a controller object.
3. Click Information/Conguration.
60