Users Guide

name=value pair 1 name=value pair 2 Description

NOTE: This command is applicable

only on 10th and 11th generation of

PowerEdge servers. On Dell’s 12th

generation of PowerEdge servers

and later, iDRAC provides capability

of automatic clear of log entries and

file backup. Only latest version of

the backup XML file is available in

the mentioned locations.

attribute=logallsensors setting=Enable|Disable Enabling the command allows you to log all

unmonitored ESM sensor events in to Alert

log, OS log, and generates the SNMP traps.

An example command set only to remove the critical severities is as follows:

omconfig preferences logging attribute=oslogfilter logcrit=false

An example command set to enable the automatic backup of ESM logs.

omconfig preferences logging attribute=archiveesmlog setting=Enable

An example command set to enable the Log All ESM Sensor Events.

omconfig preferences logging attribute=logallsensors setting=Enable

Omconfig preferences webserver

Use the omconfig preferences webserver command to set the encryption levels of the Server Administrator web server, configure

the URL launch point in the Server Administrator web server environment, and to set the JRE version for the Server Administrator.

The following table displays the name=value pairs you can use with this command:

Table 61. Valid Parameters Of Omconfig Preferences Webserver

name=value pair 1 name=value pair 2 Description

attribute=sslencryption setting=autonegotiate | 128bitorhigher

autonegotiate: Sets the encryption levels

automatically based on your web browser

settings.

128bitorhigher: Sets the encryption levels

to 128-bit or higher.

NOTE: This attribute is deprecated

in the future releases, use ciphers

instead.

attribute=seturl host=<string> port=<value>

Enables you to configure the Distributed

Web Server (DWS) URL launch point, for

accessing the management node. This

command is used when Server

Administrator Instrumentation Service and

Remote Enablement are installed on the

same system and the Server Administrator

GUI is accessed using the DWS URL.

NOTE: This command is not

supported if the web server is

present on the same system.