Users Guide
Table 52. Valid Parameters Of Omconfig Chassis Remoteaccess Or Omconfig Mainsystem Remoteaccess
name=value pair 1
config=
name=value pair 2 Description
config=additional ipv4=enable | disable
enable: IPv4 stack to load on iDRAC.
disable: IPv4 stack to flush on iDRAC.
ipv6=enable | disable
enable: Enables IPv6 stack to load on iDRAC.
disable: Disables IPv6 stack to unload on iDRAC.
NOTE: This option requires license to enable or
disable ipv6. If the appropriate license is not
installed or has expired, the system displays an
error message. For more information, see
Dell
License Manager
at dell.com/openmanagemanuals.
config=advsol characcuminterval=number
number: Sets the character accumulate interval in 5
millisecond intervals.
charsendthreshold=number
number: Sets the number of characters. BMC
automatically sends a serial over LAN data packet that
contains the number of characters as soon as this number
of characters (or greater) has been accepted from the
baseboard serial controller into the BMC.
enableipmi= true | false
true: Enables IPMI over LAN.
false: Disables IPMI over LAN.
enablenic=true | false
true: Enables DRAC NIC.
false: Disables DRAC NIC
nicselection=sharedwithfailoveronall |
nic1 |teamednic1nic2 | dracnic
sharedwithfailoveronall: Configures the new NIC selection
option.
nic1: Enables NIC 1.
teamednic1nic2: Enables NIC teaming functionality.
dracnic: Enables DRAC NIC if DRAC 5 is installed.
NOTE: The nicselection option is supported only on
PowerEdge 10G and 11G systems. From PowerEdge
12G systems onwards, primarynw and failovernw
replaces nicselection.
primarynw=dedicated | lom1 | lom2 |
lom3 | lom4
dedicated: Configures dedicated port as primary network
for remote access.
NOTE: This option requires license to configure
primarynw as dedicated. If the appropriate license is
not installed or has expired, the system displays an
error message. For more information, see
Dell
License Manager
at dell.com/openmanagemanuals.
lom 1: Configures lom1 port as the primary network for
remote access.
81