Users Guide

BIOS setup settings
The following table lists the BIOS setup attributes supported on Dell’s 12
th
generation and later PowerEdge systems. The attributes
are grouped based on the hardware configuration. The possible attributes may vary in a specific group. The omconfig chassis
biossetup command does not display the read-only attributes.
NOTE: If you have configured the setup password, then, always set the same password when you configure any BIOS
settings.
Table 44. BIOS Setup Settings on PowerEdge12G and later systems
Group name=value pair 1 attribute= name=value pair 2 setting=
BIOS Option Settings attribute=BootSeq sequence=aliasname1, aliasname2,.....
aliasnameN
attribute=HddSeq sequence=aliasname1, aliasname2,.....
aliasnameN
Boot Settings attribute=BootMode setting=Bios | Uefi
attribute=BootSeqRetry setting=Enabled | Disabled
attribute=HddFailover
NOTE: The option is supported
only on 13G and later systems.
setting=Enabled | Disabled
attribute=SetBootOrderFqdd1–
SetBootOrderFqdd16
NOTE: The option is supported
only on 13G and later systems.
setting=<string>
attribute=SetLegacyHddOrder Fqdd1–
SetLegacyHddOrderFqdd16
NOTE: The option is supported
only on 13G and later systems.
setting=<string>
Integrated Devices attribute=EmbVideo setting=Enabled | Disabled
attribute=IntegratedNetwork1 setting=Enabled | DisabledOs
attribute=IntegratedNetwork2 setting=Enabled | DisabledOs
attribute=IntegratedRaid setting=Enabled | Disabled
attribute=IntegratedSas setting=Enabled | Disabled
attribute=InternalSdCard setting=On | Off
attribute=InternalSdCardRedundancy setting=Mirror | Disabled
attribute=InternalUsb setting=On | Off
attribute=IoatEngine setting=Enabled | Disabled
attribute=OsWatchdogTimer setting=Enabled | Disabled
attribute=SriovGlobalEnable setting=Enabled | Disabled
attribute=UsbPorts setting=AllOn | OnlyBackPortsOn | AllOff
attribute=Usb3Setting setting=Auto | Enabled | Disabled
66