Users Guide

Example to Test the alarm on controller 1.
Example
omconfig storage controller action=testalarm controller=1
Omconfig Reset Controller Configuration
Table 154. Omconfig Reset Controller Configuration
Description Resets the controller configuration.
CAUTION: Resetting a configuration permanently destroys all data on all virtual
disks attached to the controller. System or boot partition residing on these
virtual disks is destroyed. You may receive a warning message if this command
results in deleting the system or boot partition. However, this warning message
is not generated always. Ensure that you do not delete the system or boot
partition or other vital data when using this command.
Syntax omconfig storage controller action=resetconfig controller=id,
where id is the controller ID as reported by the omreport storage controller command.
In some circumstances, you may receive a warning message if this command deletes
the system or boot partition. You can override this warning by using the force=yes
parameter. In this case, the syntax is as follows:
omconfig storage controller action=resetconfig
controller=id force=yes
Example to Reset the configuration on controller 1.
Example
omconfig storage controller action=resetconfig controller=1
omconfig Create Virtual Disk
The Dell OpenManage Online Help provides additional information about creating virtual disks.
The omconfig syntax for creating a virtual disk has several parameters. You must specify the following parameters:
• Controller (controller=id)
• RAID level (raid=<c| r0 | r1 | r1c | r5 | r6 | r10 | r50 | r60>
• Size (size=<number | max | min>)>
Physical disk is specified as either:
• For SCSI, SATA, and ATA controllers:
pdisk=connector:enclosureID:targetID
where connector:enclosureID:targetID is the connector number, enclosure number, and slot number.
• For SAS controllers:
pdisk=connector:targetID
where connectorID:targetID is the connector number and the slot number. For example, pdisk=0:2
Storage Management supplies default values for any of the other parameters that you do not specify.
For creating an encrypted virtual disk, specify secureflag=yes. You can create encrypted virtual disks only with SED drives.
Complete Syntax:
omconfig storage controller action=createvdisk controller=id raid=<c| r0 | r1 | r1c | r5 |
r6 | r10 | r50 | r60>size=<number | max | min> pdisk=<PDISKID> [stripesize=stripesize=<
158