Users Guide

Table 90. Omreport Physical Disk Commands
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the controller
number. For example, controller=0
Displays all physical disks attached to the
specified controller.
NOTE: If a physical disk was
replaced by another disk as part of
the replace member operation, the
state of the physical disk is
displayed as Replacing.
vdisk=id, where id is the virtual disk
number. For example, vdisk=1
Displays all physical disks included in the
specified virtual disk on the controller.
cachecade=id where id is the cachecade
number. For example, cachecade=1
Displays all physical disks included in the
specified cachecade on the controller.
connector=id where id is the connector
number. For example, connector=1
Displays all physical disks attached to the
specified connector on the controller.
pdisk=connectorID: targetID |
connectorID: enclosureID: slotID, where
connectorID: targetID is the connector
number and the physical disk number and
connectorID:enclosureID: slotID is the
connector number, enclosure number, and
slot number. For example, pdisk=0:2 or
pdisk=0:1:2
Displays the specified physical disk on the
specified connector on the controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
Table 91. omreport Virtual Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage vdisk Displays property information for all virtual
disks on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all virtual disks on the specified
controller.
controller=id vdisk=id, where id is the
controller number and the virtual disk
number. For example, controller=0
vdisk=1.
Displays the specified virtual disk on the
controller.
Omreport controller status
The following table describes the syntax for the omreport Controller commands.
129