Users Guide

Syntax Of Command Elements
The omreport and omconfig commands have multiple name=value pairs. These name=value pairs may include required, optional, and
variable parameters. The following table describes the syntax used to indicate these parameters.
Table 88. Syntax For Name=Value Pairs
Syntax Description
controller=id
Indicates the controller ID as reported by the omreport storage controller
command. To obtain these values, type omreport storage
controller to display the controller IDs and then type omreport
storage pdisk controller=id
to display the IDs for the physical disks
attached to the controller.
For example, the controller=id parameter is specified as controller=1.
connector=id
Indicates the connector ID as reported by the omreport command. To obtain
this value, type omreport storage controller to display the
controller IDs and then type omreport storage connector
controller=id
to display the IDs for the connectors attached to the
controller.
For example, the connector=id parameter is specified as connector=2.
vdisk=id
Indicates the virtual disk ID as reported by the omreport command. To obtain
this value, type omreport storage controller to display the
controller IDs and then type omreport storage vdisk
controller=id
to display the IDs for the virtual disks on the controller.
For example, the vdisk=id parameter is specified as vdisk=3.
enclosure=<ENCLOSUREID>
Indicates a particular enclosure by specifying either enclosure=connector or
enclosure=connector:enclosureID.
To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage enclosure
controller=id
to display the IDs for the enclosures attached to the
controller.
pdisk=<PDISKID>
Indicates a particular physical disk by specifying either connector:targetID or
connector:enclosureID:targetID.
To obtain the values for the connector, enclosure, and physical disk
(targetID), type omreport storage controller to display the
controller IDs and then type omreport storage pdisk
controller=id to display the IDs for the physical disks attached to the
controller.
battery=id
Indicates the battery ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs
and then type omreport storage battery controller=id to
display the ID for the controller battery.
< >
The caret symbols (< >) enclose variable elements that you must specify.
For example, the name=<string>parameter is specified as name=VirtualDisk1.
126