Concept Guide

Example for SAS
controllers
omconfig storage vdisk action=replacememberdisk controller=1
vdisk=4 source=0:2:3 destination=0:2:5
Omconfig Rename Virtual Disk
Description Renames a virtual disk.
Syntax
omconfig storage vdisk action=rename controller=id vdisk=id
name=<string>, where id is the controller ID and virtual disk ID as reported by
the omreport command and <string> is the new name for the virtual disk.
NOTE: To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example to Rename virtual disk 4 on controller 1 to vd4.
Example
omconfig storage vdisk action=rename controller=1 vdisk=4
name=vd4
Omconfig controller commands
The following table provides the omconfig command syntax required to execute controller tasks.
CAUTION: The omconfig storage controller action=resetconfig controller=id resets the
controller configuration. Resetting the controller configuration permanently destroys all data on
all virtual disks attached to the controller. System or boot partition residing on these virtual disks
is destroyed.
NOTE: If the PERC hardware controller is running in HBA mode, you can perform only one action,
exporting the log (action=exportlog).
Table 88. Omconfig Controller Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage
controller
action=rescan controller=id
action=enablealarm controller=id
action=disablealarm controller=id
action=quietalarm controller=id
action=testalarm controller=id
action=resetconfig controller=id [force=yes]
action=createvdisk controller=id raid=<c | r0 | r1| r1c | r5 | r6 | r10 | r50 |
r60> size=<number | b | m | g | max | min> pdisk=<PDISKID> [stripesize=<
2kb | 4kb | 8kb | 16kb | 32kb | 64kb | 128kb | 256kb | 512kb | 1mb >]
[cachepolicy=<d | c>] [readpolicy=<ra | nra | ara | rc | nrc>]
[writepolicy=<wb | wt | wc | nwc | fwb>] [diskcachepolicy=<default |
178