Concept Guide

name=value pair 1 name=value pair 2 Description
attribute=<ciphers> setting=<valid ciphers text
value>
Allows you to choose the ciphers
that support the web server while
configuring. SSL provides a secure
connection between the web
server and the browser. The
connection service does not start
if an invalid cipher suite is set.
NOTE: If an incorrect cipher
value is set and the
connection service fails to
start, use the CLI command
prompt or manually set the
valid ciphers and restart the
connection service.
attribute=<sslprotocol> setting=<valid sslprotocol values
are TLSv1| TLSv1.1| TLSv1.2|
TLSv1, TLSv1.1| TLSv1.1, TLSv1.2|
TLSv1, TLSv1.1, TLSv1.2
Allows you to set the web server
SSL protocols configuration from
the valid values. The changes to
take effect after web server restart.
attribute=<port> setting=<valid port value>
Sets the number of secure ports
that you want Server Administrator
to use. The port value range from
1024 to 65535. The default port
for Server Administrator is 1311.
attribute=<ipaddress> setting=<valid Binding IPAddress
value>
Sets by default the web server to
incoming browser requests on ALL
IP addresses. However, for
increased security you can specify
a single IP address or, ALL IP
addresses. An error message is
displayed on an invalid entry of the
configurable Bind List of IP
Address. For the changes to take
effect, restart the web server.
attribute=<sessiontimeout> setting=<valid Session Timeout
value between 1– 30>
Allows Server Administrator to
time-out if there is no user input
for a specified number of minutes.
Users whose sessions time-out
must log in again to continue.
An example command to set the URL launch point is as follows:
omconfig preferences webserver attribute=seturl host=<name, ip, fqdn>
port=<number>
The host input must contain a valid IPv4 or IPv6 address, or a valid host name.
An example command to set the signing algorithm value is as follows:
omconfig preferences webserver attribute=signalgorithm setting=MD5
108