Users Guide

• [-u|--update] — Updates applicable Server Administrator components.

• [-w|--web] — Installs Server Administrator Web Server.

• [-x|--express] — Installs default components. Any other options passed will be ignored. The following

components are installed::

a. Server Instrumentation

b. Storage Management

c. RAC, if applicable

d. Server Administrator Web Server

• [-z|--corecim] — Installs core CIM Interface.*

The following options can be used along with options stated above:

• [-a|--autostart] — Starts the installed services after components have been installed.

• [-p|--preserve] — Preserves the screen without clearing the installation information.

NOTE: If you do not use the [-p | --preserve] option during the installation, the history

information on the screen gets erased.

* — Options included for Linux granular installation.

Using The Shell Script To Perform The Installation In Interactive Mode

This installation procedure uses the srvadmin-install.sh to prompt you for the installation of specific

components.

1. Log in as root to the system running the supported operating system where you want to install the

managed system components.

2. Insert the Systems Management Tools and Documentation DVD into the DVD drive.

3. Mount the DVD, if required.

4. Navigate to <OM DVD mount point>/SYSMGMT/srvadmin/linux/supportscripts.

5. Execute the script with the sh srvadmin-install.sh command and accept the terms of the end-

user license agreement.

Executing the command displays a list of component options. If any of the components are already

installed, then those components are listed separately with a check mark next to them. The Server

Administrator installation options are displayed.

6. Press <c>to copy, <i> to install, <r> to reset and start over, or <q> to quit. If you press <c>, you are

prompted to enter the absolute destination path.

When the installation is complete, the script has an option for starting the services.

7. Press <y>to start the services or <Enter> to exit.

Using The Install Script To Run In Silent Mode

Perform these steps for a silent installation using the srvadmin‑install.sh shell script:

1. Log in as root to the system running the supported operating system where you want to install the

managed system components.

2. Insert the Systems Management Tools and Documentation DVD into the DVD drive.

3. Mount the DVD, if required.

4. Navigate to <OM DVD mount point>/SYSMGMT/srvadmin/linux/supportscripts.

5. To install the Storage Management Service components, type the command sh srvadmin-

install.sh --storage

(long options) OR sh srvadmin-install.sh -s (short options)