Users Guide

Connectors

A controller contains one or more connectors (channels or ports) to which you can attach disks. You can externally access a connector by

attaching an enclosure (for external disks) to the system or internally access by attaching to the backplane (for internal disks) of a system.

You can view the connectors on the controller by expanding the controller object in the tree view.

NOTE: For PCIe SSD, connectors are referred as PCIe SSD extenders.

Topics:

• Channel Redundancy

• Creating A Channel-Redundant Virtual Disk

• Connector Health

• Connector Properties And Tasks

• Logical Connector Properties And Tasks

Channel Redundancy

You can create a virtual disk that uses physical disks that are attached to different controller channels. The physical disks may reside in an

external enclosure or the backplane (internal enclosure). If the virtual disks maintain redundant data on different channels, then these

virtual disks are channel redundant. Channel redundancy is when one of the channels fail, the data is not lost as redundant data resides on

another channel.

Channel redundancy is implemented by selecting physical disks on different channels when using the Create Virtual Disk Advanced

Wizard.

NOTE:

Channel redundancy only applies to controllers that have more than one channel and that attach to an external

disk enclosure.

Creating A Channel-Redundant Virtual Disk

NOTE:

Channel redundancy only applies to controllers that have more than one channel and that attach to an external

disk enclosure.

The following instructions provide information on creating a virtual disk that uses channel redundancy.

1. Launch the Create Virtual Disk Advanced Wizard:

a) In the Server Administrator window, under the system tree, click Storage dashboard.

b) Locate the controller on which you are creating a channel-redundant virtual disk and expand the controller object until the Virtual

Disks object is displayed.

c) Select Virtual Disks and click Go To The Create Virtual Disk Wizard.

d) Click Virtual Disk Advanced Wizard.

2. Follow the steps in Create Virtual Disk Advanced Wizard.

3. Click Exit Wizard to cancel the virtual disk creation. In this step, you select the channels and the disks to be used by the virtual disk.

The selections you make determine whether the virtual disk is channel-redundant.

There are specific RAID level and configuration requirements for implementing channel redundancy. You must select the same number

of physical disks on each channel that you use. For information on the number of physical disks that can be used for different RAID

levels, see Number Of Physical Disks Per Virtual Disk. For information on controller-specific implementations of the RAID levels, see

Controller - Supported RAID Levels.

94 Connectors