Users Guide
To Change The Rebuild Rate
To change the rebuild rate:
1. Type a numerical value in the Set New Rebuild Rate (0-100) field. The value must be within the 0–100 range.
2. Click Apply Changes.
To exit and cancel your changes, click Return to Previous Page.
To locate Set Rebuild Rate In Storage Management
1. Expand the Storage tree object to display the controller objects.
2. Select a controller object.
3. Click Information/Configuration.
4. Select Set Rebuild Rate from the Available Tasks drop-down menu.
5. Click Execute.
You can also locate this task from the Change Controller Properties drop-down menu.
Resetting The Controller Configuration
Does my controller support this feature? See Supported Features.
The Reset Configuration task allows you to erase all the information on the controller so that you can perform a fresh configuration.
This operation destroys all data and virtual disks on the controller and unassigns any hot spares.
You must completely reconfigure the storage after performing this reset operation.
CAUTION:
Resetting a configuration permanently destroys all data on all virtual disks attached to the controller. If the
system or boot partition resides on these virtual disks, it is destroyed.
NOTE: Resetting the controller configuration does not remove a foreign configuration. To remove a foreign
configuration, select Clear Foreign Configuration task.
NOTE: This task is not supported on PERC hardware controllers running in HBA mode.
Related concepts
Reset The Controller Configuration
To Locate Reset Configuration In Storage Management
Changing The Controller Properties
Reset The Controller Configuration
To reset the controller configuration:
1. Review the virtual disks that are destroyed by resetting the controller configuration. Make backups as necessary. Click Blink at the
bottom of the page to blink the physical disks included in the virtual disks.
2. Click Reset Configuration when you are ready to erase all information on the controller.
To exit without resetting the controller configuration, click Go Back to Previous Page.
To Locate Reset Configuration In Storage Management
1. In the Server Administrator window, under the system tree, expand Storage to display the controller objects.
2. Select a controller object.
3. Click Information/Configuration.
4. Select Reset Configuration from the Available Tasks drop-down menu.
5. Click Execute.
You can also locate this task from the Change Controller Properties drop-down menu.
Controllers
57