Connectivity Guide

iDRAC MIB

The Integrated Dell Remote Access Controller (iDRAC) MIB (filename iDRAC-SMIv1.mib/ iDRAC-

SMIv2.mib) is the MIB supported by the Integrated Dell Remote Access Controller 7 and 8 (iDRAC7 and

iDRAC8). This MIB provides management data that allows you to monitor devices and software on a

system via an out-of-band connection to the iDRAC7 and iDRAC8 of a system.

NOTE: From iDRAC7 firmware release r1.30.30 or later and iDRAC8, the iDRAC7 or iDRAC8 MIB file

is published in both types of SMI (Structure of Managed Information) notations: SMIv1 and SMIv2.

The SMIv1 copy of the iDRAC7 or iDRAC8 MIB file is named iDRAC-SMIv1.mib. And the SMIv2 copy

is named iDRAC-SMIv2.mib. Prior to iDRAC7 firmware release r1.30.30, only a SMIv1 copy was

published. And the file name of the SMIv1 copy was iDRAC-MIB.txt.

Supported Systems

The iDRAC MIB supported on the following systems for this release:

Blade Servers

The Blade servers for this release:

• PowerEdge M830

• PowerEdge FC430

Rack and Tower Servers

The Rack and Tower servers for this release:

• PowerEdge R930

• PowerEdge R530xd

• C6320

• PowerEdge FX2/FX2s 1.2

• PowerEdge FD332

• DSS 2500

• DSS 1500

iDRAC Supported SNMP Versions

The following table identifies the SNMP versions that support iDRAC for the given SNMP operations.