Connectivity Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Server Administrator Version 8.2

drsProductChassisLocation, drsGlobalCurrStatus, drsCASubSystem, drsCASSCurrStatus,

drsCASSPrevStatus, drsCASSChangeTime and drsCAMessage.

PowerEdge M1000e CMC version 5.0 and later supports a setting to generate the traps listed in the

section "PowerEdge VRTX CMC Traps and PowerEdge FX2 CMC Traps". The setting is named "Enable

Enhanced Chassis Logging and Events" in the PowerEdge M1000e CMC GUI and is located in the General

Chassis Settings page which can be found by navigating to Chassis Overview -> Setup -> General in the

CMC GUI. When the setting is disabled, the traps listed in this section are generated by the CMC. When

the setting is enabled, the traps listed in the section "PowerEdge VRTX CMC Traps and PowerEdge FX2

CMC Traps" are generated by the CMC instead of the traps listed in this section. The setting is disabled by

default. The trap variables are defined in the Dell Remote Access Controller Out-of-Band Group section.

Table 121. PowerEdge M1000e CMC traps

TrapID Name Description Severity Category

2000 alertCMCTestTrap CMC has generated a

test trap.

Informational Error Events

2002 alertCMCNormalTrap CMC reported a return-

to-normal or

informational event.

Normal Error Events

2003 alertCMCWarningTra

CMC reported a warning

event.

Warning Error Events

2004 alertCMCCriticalTrap CMC reported a critical

event.

Critical Error Events

2005 alertCMCNonRecove

rableTrap

CMC reported a

catastrophic event.

Non-Recoverable Error Events

PowerEdge VRTX CMC Traps and PowerEdge FX2 CMC

Traps

This section defines the traps that are generated by the SNMP agent of the PowerEdge VRTX CMC and

PowerEdge FX2 CMC. All of the enterprise-specific traps documented in this section belong to the MIB

enterprise identified by OID 1.3.6.1.4.1.674.10892.2.21 and are sent with the following trap variables:

drsCA2MessageID, drsCA2Message, drsCA2MessageArgs, drsCA2AlertStatus, drsCA2FQDD,

drsProductChassisName, drsProductChassisLocation, drsChassisServiceTag and drsGlobalCurrStatus. The

trap variables are defined in the Dell Remote Access Controller Out-of-Band Group section.

System Trap Group

The System Trap Group contains traps that fall under the System event category.

Table 122. Amperage Probe Traps

TrapID Description Category SubCategory Severity

alert2AmperageProbeNormal

2179 Current sensor reading is

within range.

Status Events Amperage Information

alert2AmperageProbeWarning